Scope RS232 Manual do Utilizador descarregar pdf (Página 4)

FLB/TLB-2x-Scope V1.0 (KW 09/2006 - 03.03.2006) 4

The function of the individual FLB-CON2-2X control elements will be explained

on the following pages:

REF1 and TOL1 setting:

Entering a value in the REF1 edit-box teaches the reference for the first

window.

Entering a value in the TOL1 edit-box applies a ±tolerance around this

value.

REF2 and TOL2 setting:

Entering a value in the REF2 edit-box teaches the reference for the second

window.

Entering a value in the TOL2 edit-box applies a ±tolerance around this

value.

DYN_LO and DYN_HI:

The two function fields DYN_LO and DYN_HI are used for setting a

lower and higher dynamic range limit for the sensor. When the sensor is

within the dynamic range (DYN-LO < DATA < DYN-HI), the dynamic

check output (green LED at the sensor housing) is active.

HYST:

The hysteresis setting value lies below or above the current reference

window (REF1 ± TOL1, REF2 ± TOL2). The switching hysteresis affects

the corresponding digital output. It increases the signal stability at the

digital output of the electronic control unit FLB-CON2-2X.

POLARITY:

Determines the polarity change of the digital outputs when the value rises

above or falls below the respective thresholds.

AVERAGE:

Determines the number of measured values (raw data) over which the

sensor signal arriving at the receiver is averaged (noise suppression).

1 2 3 4 5 6 7 8 9 10

Sem comentários

Scope RS232 Manual do Utilizador Página 4